Suomy Mr. Jump Lazyboy Grey
Der neue Hightech Helm von Suomy!
Komplett neu gestaltet mit einem Gewicht von sensationellen 999 g (+/- 50 g).Komplett austrennbares Coolmax Innenfutter.
Neckbrace kompatibel.Gefertigt aus Carbon/Aramid.
Geprüft nach ECE 2205 und Rennsport zugelassen.Permanentes Belüftungssystem mit Kanälen durch die Innenschale des Helmes.
Absoluter Profihelm der zum Bs. vom CLS Kawasaki Team eingesetzt wird.
Material: Schutzartikel für den Sport
For maximum safety MR JUMP must fit tightly and be correctly and securely fastened, so it cannot be taken off neither by pulling it nor by rotating it around the head.
If it is too big it may slide down over the eyes or turn in a lateral direction due to movement during riding, thus blocking visibility.
Shell available in two sizes (M, L), and handmade in Italy. The new composite material is combination of carbon and aramidic fibre.
Internal polystyrene protective liner, available in two sizes (M and L). The special shape and construction featuring differentiated density increases mechanical resistance in the event of accidental shocks.
The particular shape of the interior shell, was studied so as to reduce impact angles with the rider’s body while permiting the use of most of the modern Neck Braces.
The D-RING retention system is designed and patented by Suomy: this reliable and tested double D ring system ensures stability, safety and resistance.
How to use: insert the free side of the strap in the rings.
Pull the end until the strap presses firmly against the jaw.
After this operation, it should not be possible to remove the helmet. Verify that by grabbing it from the back and rotating it to the front it cannot be removed and it is fixed to the head.
If the helmet tends to come off or rotates freely, tighten the strap again until the right pressure is obtained and repeat test.
If after repeating the test you are not able to efficiently tighten the retention system, do not use the helmet.
Only after checking the correct tension of the strap, fix the free end locking it with the automatic stud to the release tab
The automatic stud is necessary only to fix the free end of the strap to prevent it from flapping while riding. Fixing the release button does not assure that the helmet is correctly in position and properly fastened: the correct locking of the strap must be verified exclusively following the above paragraphs.
To release the retention system, release the automatic stud button and pull the release tab to loosen the closure. Slide out the free end of the strap from the «D Rings».
Use the release tab only to remove the helmet! Never release this tab while riding.
If the retention system does not work properly, do not use the helmet and contact Suomy authorized personnel only.
Completely removable and washable cheek pads are available in different thicknesses for complete customization of the final product.
Completely removable and washable internal shell is available in different thicknesses for complete customization of the final product.
The removable internal shell has been ergonomically designed for a uniform and controlled fit of the entire head. The visible aeration slots ensure that incoming air thermo-regulates the inside of the helmet and that the flow of hot air is easily discharged from the rear.
The internal elements (cheek pads and internal shell) are made entirely of COOLMAX® ACTIVE fabric with INTERPOWER treatment:
Wicks sweat away from the body;
Keeps the user fresh, dry and comfortable;
Lightweight, soft and breathable fabric;
Performance verified and certified by ADVANSA.